JA-196PL-L Holder for dual PIR and MW detector for wall

Plastic cover for radio module JA-111R installed at the factory in the control panel (eg set JA-101KR, JA-106KR, etc.). It is designed for mounting the radio module outside the control panel of the security system.

The holder was designed for mounting PIR motion detectors of the JA-1x2P series into a plasterboard or brick wall. Thanks to this method of mounting, the detector is partially recessed and blends elegantly with the wall.

Alternative lens to PIR detectors.

Masked camera in pir alarm detector - JA-60 / 480 TV

Color camera 480 TV řádků, 0.2 lux

High-quality camera hidden in the cover from the PIR sensor inconspicuous appearance fine grille instead of lens

480 rows lens 3.6mm usable Video lenses, or Direct Drive power 12V DC 3.7mm lens, 1/3" Sharp CCD DSP processor to control image high sensitivity, image quality, s/s functions electronic shutter (AES) car. profit management (AGC), by car. white balance (AWB) anti-aliasing and optical filter against IR light

Alternative lens to PIR detectors.

Alternative lens to PIR detectors.

The holder was designed for mounting PIR motion detectors of the JA-1x1P series in a plasterboard or brick wall. Thanks to this method of mounting, the detector is partially recessed and blends very elegantly with the wall.

Common type of signal interference detector that detects malicious mobile phones / GPS connection interruptions

Fleet management uses GPS tracking systems for trucks, trailers, vans and rental cars. The continuous inspection shall update information on the locations and destinations of vehicles which differ or disappear from the intended routes or exceed specific restrictions.

The radar motion sensor operates on a different principle from the normal PIR sensor. This sensor is equipped with a very sensitive and reliable sensor that works on the principle of transmitting high frequency radiomagnetic (radar) waves. If the field is disturbed by movement, the sensor will start the light. The sensor also works through doors, windows or thin walls. For the sensor it is possible to control the range (2 - 8m), time, twilight settings or whether it turns off before opening the door or only after opening it.

It is used to attach PIR motion detectors of the JA-1x1P and JA-1x2P series to the ceiling or wall in case of need for a different positioning than the standard mounting allows.