The intelligent non-contact liquid level sensor is used to determine if there is liquid in the pipe / container. It changes the state of the output when it is detected that liquid is passing through the measured object. The water level sensor works contactless up to 20 mm wall (plastic) of the container.
The liquid level detector is a controller with 3 XKC-Y25V / 22 sensors. The user can install 2 pcs on the top and bottom of the container and others on the inlet or outlet or overflow level to intelligently detect the liquid level. Then the controller to control the motor or output pump or input pump or alarm system and so on as a user application.
Features:
1> .Contactless detection
2>. Easy installation
3>. The light indicates the test result
4> .Stable detection
5>. High sensitivity
6>. Strong anti-interference capability
7>. Support to detect various fluids
8> .Adjustable sensitivity
9> .800W Load control
10> .Automatic level control
Parameters:
1>. Contactless fluid level sensor controller
2>. Product number: XKC-C382-3P (GY18290)
3> .Operating voltage: 230V 50Hz
4> .Output type: Voltage output
5> .Power consumption: <2W
6> .Output voltage: V-in
7>. Response time: 500 ms
8> .Sensor thickness (sensitivity) Range: 0-20mm
9>. Driver material: ABS + PC refractory materials
10>. Sensor material: ABS materials
11> .Error value: +/- 1.5mm
12>. Waterproof performance: IP65
13>. Load power:
13.1>. Less than 1600 W for an impedance load such as a heater
13.2> .Less than 1000W for an inductive load such as a motor
13.3>. Less than 800W for alarm system
14>. Operating temperature range: -20 ℃ ~ 85 ℃
15>. Working humidity range: 5% -100% RH
16>. Driver size: 116 * 116 * 39mm
17>. Sensor cable length: 100 cm
Function:
1>. Normal sensor: The alarm system works after 5 seconds if it switches off at low water level or switches on at high water level.
2>. Abnormal overflow: The alarm system works after 3 seconds if it is simultaneously ON for low / high / overflow water level.
3>. Abnormal supply: The alarm system works after 25 seconds if you leave it in the off state for the low water sensor.
4> .It is suitable for non-metallic pipes / vessels. No need to place in a pipe / container. Directly attached to the surface of the pipe / vessel.
5>. Supports adjustable sensitivity. Turn the potentiometer to adjust the sensitivity. Turning counterclockwise increases sensitivity.
6>. No direct contact with liquid is required.
7>. It is not damaged by corrosive liquids such as strong acid and alkali.
8>. It is not affected by impurities such as limescale.
9> .Can also control boiling water.
10>. It is a purely electronic circuit, not a mechanical one.
11>. It can penetrate various non-metallic containers such as plastics, glass, ceramics, acrylic, rubber, etc.
12>. It supports the detection of liquids, powders, granular substances.
Note:
1>. It cannot be in direct contact with the liquid and cannot be placed in the liquid.
2>. It cannot test through metal piping.
3>. Read the instructions for use and description before use.
Application:
1> .Water tower
2> .Wastewater treatment
3> .Dron irrigation
4> Medical equipment
5> .Aquarium
6> .Intelligent appliances
