Moving LED light, light strip control with movement 1516, car lighting control for stairs, corridors. Led strip lighting-up effect
Illuminate efficient stairs, corridors with an addressable LED moving strip - white color. The light is activated by movement and then the LED light follows your path and shows you the direction. The device does not have a network adapter. The suitable power adapter is 12V/ 3A. Positive and negative power supply terminals of the controller cannot be reversed, the red V+ wire is connected to the positive electrode of the switching source and the blue (or black conductor) V - is connected to the negative pole of the power supply.
Product packaging:
Set of 10m LED strips
LED controller with sensor
hot/cold white LED strip light
motion sensors
Product parameters:
Input voltage: DC 5-24V
PIR shooting distance: 5 - 10 m
Installation Diagram - Operation of product setup:
1. Long press to set the number of steps to turn on the LED light, one press to add six leds with the LED strip itself. (two-stage stairs). After you've set up a successful setup, long press a key. You set how many LED lights should be active from the LED strip itself. Because the device does not know the length of the LED belt, or if you shorten it, it is necessary to adjust the length of the LED strip by 24-1m to the very end.
2. Press and hold the button again to adjust the speed at which the LED lights are lit. The more red lights on the electronics device itself, the lower the speed of switching the LED belt. When the setting is complete with a successful setting, long press the key.
Connectors 1 to 4 connect LED strips, so you can connect up to four LED strips at a time. The hallway or stairs are sufficient one at a time on both sides. It is advisable to place the LED strip itself in the aluminium strip, where it is glued, thus ingesting the passive cooling of the LED strip and its long service life. The LED strip is not a problem to place away from the control electronics with the enclosed extension cables. It is not advisable to line the LED strips in a row, this creates quite a lot of consumption on the LED strip itself, i.e. its heating even with a higher flow current through the LED strip.
Connectors A, B are used to connect a PIR sensor to detect movement. It is also not a problem to place them away from the control electronics with the supplied extension cord.
